Access Control : How to RESET control unit with SW1 & SW2 buttons ?

Gewijzigd op Do, 30 Dec, 2021 om 3:26 PM

This article is not available in Portuguese/Portugal, view it in French

SW1 to erase memory of the control unit :

- Power off the control Unit.

- Hold SW1 Swtich while restoring Power.

- Wait for the blue LED on the expansion bus to light up (approximately 10 seconds) while holding the switch down.

- Release SW1

SW2 to restore factory network settings (IP address : 192.168.2.150, mask 255.255.255.0).

- Power off the control Unit.

- Keep the switch pressed while turning the power back on.

Remark :

- To configure the control unit with a fixed IP address, release the switch at the first flash of the extension bus LED (about 5 seconds).

- To configure the control unit in DHCP mode, wait for the second flash of the extension bus LED (approximately 5 seconds after the first flash).

- Release SW2